Jump to content

Talk:Victoria line

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia
Good articleVictoria line has been listed as one of the Engineering and technology good articles under the good article criteria. If you can improve it further, please do so. If it no longer meets these criteria, you can reassess it.
Did You Know Article milestones
DateProcessResult
April 6, 2010Good article nomineeNot listed
January 5, 2015Peer reviewReviewed
October 27, 2018Good article nomineeListed
Did You Know A fact from this article appeared on Wikipedia's Main Page in the "Did you know?" column on December 2, 2018.
The text of the entry was: Did you know ... that the London Underground Victoria line (train pictured) was so named because it sounded "just right"?
Current status: Good article

Station spacing

[edit]

The Service and rolling stock section says "because of its evenly spaced stations" - this is demonstrably untrue. Kings Cross is much closer to Euston (0.75 km) than to Highbury & Islington (2.43 km). --Redrose64 🌹 (talk) 07:52, 14 September 2018 (UTC)[reply]

And from H&I to Finsbury Park is one of the longest underground gaps in the network. Better get rid of that misinfo. —SerialNumber54129 paranoia /cheap sh*t room 08:09, 14 September 2018 (UTC)[reply]
By "because of its evenly spaced stations" means you don't have the situation such as Leicester Square and Covent Garden being right next door to each other. The HMSO source also adds, "Finally, by having fewer stations than the Piccadilly Line between King's Cross and Finsbury Park, the Victoria Line would be faster over that stretch". I think "fewer stops" describes it best. Specifically, I was thinking about the "hack" from Morden to Kings Cross by getting on the Victoria at Stockwell instead of staying on the Northern, which is reportedly faster (though I didn't have a stopwatch). Ritchie333 (talk) (cont) 09:46, 14 September 2018 (UTC)[reply]
I agree that's what it means; but "evenly-spaced" means something else to the reader, and is not a reflection of the source. It seems to have been adjusted though, so all's well. —SerialNumber54129 paranoia /cheap sh*t room 09:50, 14 September 2018 (UTC)[reply]
Perhaps "long-stretches between stations outside of Zone 1 / centre of London"; North of King's Cross there generally 2 kilometres / 1.5 miles between stops (Tottenhale Hale excepted). —Sladen (talk) 10:19, 14 September 2018 (UTC)[reply]

Wrong dates

[edit]

There is a problem with the dates, some of the stations opened in 1870s.. So how the hell did the line open in 1960s, a good 90 years later.150.101.100.140 (talk) 03:38, 2 December 2018 (UTC)[reply]

Because this line was built to connect already-existing stations on other lines, and consequently every station on this line (with the exception of Pimlico) already existed before the Victoria Line was built. ‑ Iridescent 09:04, 2 December 2018 (UTC)[reply]

Jean Charles de Menezes

[edit]

There appears to be an edit war about whether the Shooting of Jean Charles de Menezes belongs in this article. The source given is "Man shot in terror hunt was innocent young Brazilian" from The Observer, but this does not mention the Victoria line anywhere and says de Menezes was shot in Stockwell tube station. The article on the shooting does not mention the Victoria line; it implies that de Menezes was travelling from Stockwell to Kilburn tube station which would normally involve the Victoria line to Green Park and changing to the Jubilee, but it could also involve the Northern Line Charing Cross Branch and changing at Waterloo. Ritchie333 (talk) (cont) 11:40, 12 April 2021 (UTC)[reply]

I would argue that the Shooting of Jean Charles de Menezes best belongs in the Stockwell tube station article. It's not notable to the Victoria line itself. Similar edits have been made to District line regarding the Parsons Green train bombing by the same IP editor - again, notable in the Parsons Green tube station article, but not the District line. Turini2 (talk) 14:18, 12 April 2021 (UTC)[reply]
Ditto with Northern line too - similar looking edits from another IP. Turini2 (talk) 14:20, 12 April 2021 (UTC)[reply]
The entries are inaccurate, de Menezes was not a tourist but working as an electrician. Murgatroyd49 (talk) 09:47, 14 April 2021 (UTC)[reply]

The Extension Of Victoria Line

[edit]

The Extension Will Began The construction In 2027. From Brixton-Nunhead This Will Be Above Grounds

Please stop guessing about what might happen. --Redrose64 🌹 (talk) 15:39, 27 November 2021 (UTC)[reply]

Claim on ATO upgrade

[edit]

There is a cited comment in the 'service and rolling stock' section that the replacement of the signalling system was the "world's first ATO-on-ATO upgrade", but I think it is important to point out that this is not true. The Tsuen Wan Line of the MTR in Hong Kong had its Westinghouse Block Work ATO system upgraded to SACEM in 1996, with the Kwun Tong Line and Island Line following suit by 1998. I know for a fact this is true, but the only source I can find right now that mentions MTR using Westinghouse and then switching to SACEM is this forum thread.

I know the source isn't perfect but I still think the claim that the Victoria line is the world's first ATO-on-ATO upgrade should either be corrected or removed as it is simply not true. KeepElephant (talk) 16:06, 11 April 2024 (UTC)[reply]

To be strictly accurate the comment is that the replacement signalling system was claimed by LUL to be the world's first. As such the statement is true. They did make that claim. Murgatroyd49 (talk) 16:21, 11 April 2024 (UTC)[reply]
@KeepElephant Was it even ATO? That (self published) source says Westinghouse Block Work ATP (which could be GoA1). Another source states "When the MTRC system opened the first line in 1979, the train control system was quite novel at the time. It was the Westinghouse speed-code ATP system, with no trackside running signals. The interlocking was the route relay interlocking. Remote control, train describer and ATSS were also installed. Track circuits were a mixture of CVCM, HVI, 50Hz etc. and point machines were electro-hydraulic clamp locks. Axle counters were introduced at about the same time as the KCRC, in 1986." Obviously ATP ≠ ATO, so another source is needed.
There's also an argument that SACEM isn't always ATO - the use of it on the Paris RER was not an ATO system originally, it was upgraded in the 2010s. Turini2 (talk) 16:40, 11 April 2024 (UTC)[reply]
I have found this site which does mention ATO on the ATP of the Block Work. And it is true that SACEM isn't always ATO but MTR had ATO since day 1. I don't edit often (and please don't use this to disregard my comments) but from what I can tell, most Hong Kong-based sites that get technical about trains lead to the linked site (HK Rail Engineering Centre).
And as for @Murgatroyd49 LUL did make the claim, but my point is that I think it's misleading to readers to leave it there without mentioning the Tsuen Wan Line, which is in fact the world's first ATO on ATO upgrade to the best of my knowledge. Not about whether LUL made the claim but the correctness of the claim. KeepElephant (talk) 17:02, 11 April 2024 (UTC)[reply]
First let me assure KeepElephant that no Wikipedia editor whom I respect considers the frequency of other people's editing. (But whether they have a named account or just use an anonymous URL - that is another matter.) I take his point that the truth of LUL's claim is significant. Unfortunately, I don't read Chinese so I cannot verify the cited sources. A statement that LUL are making bogus claims requires proper citation. OrewaTel (talk) 08:26, 15 April 2024 (UTC)[reply]
The first ATO system was invented in Paris metro in 1951. It was tested between 1952 - 1956; it was introduced on line 11 in juin 1969.
https://fr.wikipedia.org/wiki/Pilotage_automatique_du_m%C3%A9tro_de_Paris Evgueniy Krylov (talk) 10:03, 15 November 2024 (UTC)[reply]
Not sure that is relevant to this particular discussion about ATO to ATO upgrades? Turini2 (talk) 10:48, 15 November 2024 (UTC)[reply]